Calibration of Herbicide Applicators
Vol. 2020 No. 4, Agronomy Department
Vol. 2020 No. 4

Calibration of Herbicide Applicators: SS-AGR-102/WG013, rev. 05/2020

Agronomy Department
https://doi.org/10.32473/edis-wg013-2020
Published 2020-08-13
Jason A. Ferrell
University of Florida
Brent A. Sellers
University of Florida
https://orcid.org/0000-0001-6164-780X
Pratap Devkota
University of Florida
Measuring nozzle spacing to determine “W.”
view on EDIS

Supplementary Files

PDF-2020

Keywords

gallons per acre
gallons per minute
sprayer output

How to Cite

Ferrell, Jason A., Brent A. Sellers, and Pratap Devkota. 2020. “Calibration of Herbicide Applicators: SS-AGR-102/WG013, Rev. 05/2020”. EDIS 2020 (4). Gainesville, FL. https://doi.org/10.32473/edis-wg013-2020.
APA Chicago IEEE MLA

Download Citation

Endnote/Zotero/Mendeley (RIS) BibTeX

Abstract

If pesticide applicator equipment is not properly calibrated, the pesticide will probably be applied below or above the desired application rate. This 3-page document discusses the two most common methods for sprayer calibration. Written by Jason A. Ferrell, Brent A. Sellers, and Pratap Devkota, and published by the UF/IFAS Agronomy Department, revised May 2020.

Previous version:

Ferrell, Jason, and Brent Sellers. 2009. “Calibration of Herbicide Applicators”. EDIS 2009 (10). https://journals.flvc.org/edis/article/view/118262.

https://doi.org/10.32473/edis-wg013-2020
view on EDIS

This work is licensed under a Creative Commons Attribution-NonCommercial-NoDerivs 4.0 International (CC BY-NC-ND 4.0) license.

Most read articles by the same author(s)

1 2 3 4 5 > >>