Three-Dimensional Sampling Method for Characterizing Ant Mounds
Abstract
A field-portable 3D laser scanner was employed as a means of digitizing the surface of fire ant (Solenopsis invicta Buren) mounds for analysis of shape and orientation in Mississippi and Oklahoma. Estimates of above-ground mound volume obtained through manual measurements of mound length, width, and height were higher and more variable than estimates obtained by summing the area underneath interpolated mound surfaces. Mounds were typically elliptical in shape and oriented in a north-south direction. The mound apex was offset to the northeast of the mean mound center by an average of 46 ± 5 mm. Additional mound characteristics extracted from 3D data included slope (degrees), surface area, and slope within mound aspect (northeast, southeast, etc.). Advantages of the methodology employed in this study and possible explanations for fire ant mound shape are discussed.View this article in BioOne
Downloads
Published
Issue
Section
License
Copyright for any article published in Florida Entomologist is held by the author(s) of the article. Florida Entomologist is an open access journal. Florida Entomologist follows terms of the Creative Commons, Attribution Non-Commercial License (cc by-nc). By submitting and publishing articles in Florida Entomologist, authors grant the FOJ and Florida Entomologist's host institutions permission to make the article available through Internet posting and electronic dissemination, and to otherwise archive the information contained both electronically and in a hard printed version. When used, information and images obtained from articles must be referenced and cited appropriately. Articles may be reproduced for personal, educational, or archival purposes, or any non-commercial use. Permission should be sought from the author(s) for multiple, non-commercial reproduction. Written permission from the author(s) is required for any commercial reproduction.
